You are already signed in. This page registers one device to your account; it does not create or modify your account.
Flash and configure this device
Use Chrome or Edge on your computer.
Connect the ESP32-C3 with a data-capable USB cable.
Click Flash firmware and select the ESP32-C3. If it keeps connecting, use the BOOT-button recovery steps below.
If the installer says it cannot connect: unplug the board, hold its BOOT button, plug it in while still holding BOOT for 3 seconds, then release it and retry. After flashing completes, wait 5 seconds, unplug/reconnect, then configure it.
Recovery: If the board is repeatedly rebooting, unplug USB. Hold BOOT, reconnect USB, keep holding for 3 seconds, release, then click the flash button again. Use Chrome or Edge and close Arduino Serial Monitor.